2001.gif (38494 bytes)

logonoborder.gif (6994 bytes)

 

Coil Turns Analyzer

Model 2001

(Formerly manufactured by
Wabash Magnetics, Inc.)

Description
The Model 2001 analyzes coils in motors, transformers and other electromagnetic devices and determines the number of turns in an air core coil. The Coil Turns Analyzer, engineered for speed and accuracy, can nondestructively determine the number of turns within ± 0.1% or one turn, whichever is greater.

Typical Applications

  • Determining the number of turns on an unknown coil
  • Checking conformance of a coil to specifications
  • Determining the resistance of coils, resistors and inductors
  • Checking for proper lead arrangements, polarity and direction of windings
  • Checking transformer coil ratios
  • Non-destructive reliability testing

Features

  • Logic and Control Panel
  • Master Coil Module with Plexiglass Guard
  • Specially Treated Energizing Rods
  • Production HI-LO Limit Switches
  • Digital Display for Turns and Resistance

Model 2001 Coil Turns Analyzer
The Model 2001 is designed to save time and money. To measure turns and polarity place the mode switch in "Turns", then place an unknown (test) coil over an energizing rod and connect two clips leads to the test coil.   Press the "Test" button to initiate the measurement cycle. The number of turns is displayed and the polarity is shown on the polarity indicator. To test turns and resistance limits set the mode switch to "Limit Check" and repeat the steps above.  Pass/fail indicators for turns and resistance, the number of turns, and polarity indicators are displayed.  The Model 2001 is designed to operate from a standing stool high position. It has a guaranteed accuracy of ± 0.1% or one turn, whichever is greater (applies to the 7/64" diameter energizing rod). Accuracy is slightly reduced when using the 5/64" diameter rod.

Benefits

Operating Specifications:

Coil Size

Energizing Rod

Precision
ID min OD in Length in Accuracy

Resolution
7/64 .104 24 ±.1% or 1 turn 1 part in 5,000
5/64 .074 16 ± .2% or 1 turn 1 part in 1,000

Specifications

Power Requirements: (Specify at time of order)
120 VAC, 50/60Hz,
15 Amp
220 VAC, 50/60Hz, (Optional)		 Dimensions: Cabinet/Enclosure
Width: 22.0 in (55.8 cm)
Height: 50.0 in (127.0 cm)
Depth: 27.0 in (68.6 cm)		 Writing Surface
Width 22.0 in (55.8 cm)
Depth 12.0 in (30.5 cm)
Weight:
Approximately 200 lb
Measurement Ranges:
1 Turn to 99,999 Turns
.1 Ohm to 9,999.9 Ohms.		 Speed of Operation:
Digital readout 2-3 seconds typical (5 second maximum)
Hi-Low limit check one (1 second maximum)

Specifications subject to change without notice.

HOME SITE MAP BACK

Contact our factory for additional information.
Magnetic Instrumentation Inc., 8431 Castlewood Dr., Indianapolis, IN 46250-1534
E-mail: maginst@maginst.com, Tel. 317-842-7500, Fax 317-849-7600